All stock codes associated to this product
KVR1333D3N9K2/8G, 1053826, XKVR1333D3N9K28G, 740617148374
KVR1333D3N9K2/8G 8GB (4GB 512M x 64-Bit x 2 pcs.) PC3-10600 CL9 240-Pin DIMM Kit
DESCRIPTION:
ValueRAM's KVR1333D3N9K2/8G is a kit of two 512M x 64-bit 4GB (4096MB) DDR3-1333 CL9 SDRAM (Synchronous
DRAM) memory modules, based on sixteen 256M x 8-bit DDR3-1333 FBGA components per module. Total kit
capacity is 8GB. The SPDs are programmed to JEDEC standard latency 1333Mhz timing of 9-9-9 at 1.5V. Each 240-
pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:
FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
PERFORMANCE:
CL(IDD) - 9 cycles
Row Cycle Time (tRCmin) - 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) - 160ns
Row Active Time (tRASmin) - 36ns (min.)
Power - 1.380 W (operating per module)
UL Rating - 94 V - 0
Operating Temperature - 0o C to 85o C
Storage Temperature - -55o C to +100o C
