|
|
265.00x101.00x125.00(mm) 10.43x3.98x4.92(inch) |
|
|
VOLTAGE:90V~264VAC FREQUENCY:47Hz~63Hz INPUTCURRENT:20-10AMAXATANYLOW/HIGHINPUTVOLTAGE INRUSHCURRENT:60/100A@115/230VAC(25) POWERFACTORCORRECTION:95%@110V,FULLLOAD |
|
|
|
|
|
Output Voltage |
Output Current Min. |
Output Current Max. |
Output Current Peak |
Regulation Load |
Regulation Line |
Output Ripple & Noise Max.[P-P] |
5V |
4 |
48.00 |
|
5% |
50mV |
70mV |
|
|
|
-5V |
0.2 |
1 |
|
+5%, -10% |
50mV |
120mV |
|
|
|
-12V |
0.2 |
1.5 |
|
+5%, -10% |
50mV |
120mV |
|
|
|
+5VSB |
0.4 |
3.5 |
|
+5%, -6% |
50mV |
70mV |
|
|
|
|
REMARKS: 1. THE OUTPUT POWER OF 5V AND 3.3V MAX:40A 2. EACH POWER MODULE OUTPUT MAX:420W 3. TOTAL OUTPUT POWER MAX:760W
|
*TEMPERATURE RANGE: OPERATING: 0 --- 40 STORAGE: -20 --- 80 *HUMIDITY:OPERATING:20%-95%, NON-OPERATING:10%-95% *REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS *HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE *DIELECTRIC WITHSTAND: INPUT / OUTPUT 3000 VAC FOR 1 SECOND INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND *EFFICIENCY: 65% TYPICAL AT 115VAC FULL LOAD *POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms *OVER POWER PROTECTION: 110% ~ 180% *OVER VOLTAGE PROTECTION: +5V -> 5.7V ~ 6.5V, 3.3V ->3.9V ~ 4.7V +12V -> 13.3V ~ 14.3V OVER CURRENT PROTECTION: 110% ~ 180% *SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V *EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A *SAFETY: UL 1950, CSA 22.2 NO/ 950, TV IEC 950 *REMOTE ON / OFF CONTROL *THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY), AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE, AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE. *3.3V REMOTE SENSING |
|
|
|
|