S45299 | AXIS T8129 Power over Ethernet extender repeates the data

AXIS T8129 PoE Extender is compatible with all Axis network video products with PoE, and supports both IEEE 802.3af and IEEE 802.3at. Check in the Typical set-up section for connection examples with Axis network video products.

Range depends on the power required, so a 25 watt PTZ dome camera may be located 200 m (656 ft.) away using a single AXIS T8129. Or, the cable length to a regular 5 watt network camera may extend up to 400 m (1312 ft.), by fitting three AXIS T8129 at 100 m (328 ft.) intervals. Check in the Range tab for information about Maximum distances.

The table below shows the maximum distances from the network switch depending on power source, by adding an Axis PoE Extender for every 100m (328ft). The actual figures will depend on operating conditions. The range is over 24AWG (or heavier) CAT5e or CAT6 cable except where specified:

Note: The actual figures depend on operating conditions. Range is over 24 AWG or heavier CAT5e or CAT6 cable except where specified.

* use 23 AWG or heavier cable (typically CAT6)
** Axis 30W midspans are fully 802.3at compliant but operate at a higher voltage than most PoE+ switches, therefore it enables longer ranges then most normal PoE+ Switches.

AXIS T8129 does not require any additional power supply and the connected network camera is fed by a single PoE switch or midspan. It offers two female Ethernet ports, which are both configured automatically for link speed, duplex and crossover and the full-rate network throughput is maintained.